When you add a new session, Auto-fill previous setup copies the chassis, tires and engine setup from an earlier session. You can start from what you ran last time and change only what is different.
Auto-fill works only on new sessions. It never changes a session you open with Edit session.
Which session the setup comes from
Auto-fill starts when you choose a track. Until then, Chassis setup, Tires setup and Engine setup are greyed out. Kartnote uses the current driver's sessions at that track, up to the session's Date, and copies the most recent match in this order:
- The latest session with the same Kart.
- If there is none, the latest session with the same Class.
- If there is none, the latest session at that track.
If no session matches, the setup starts empty.
Why the setup changed
Kartnote looks up the setup again each time you change the Track, Kart, Class or Date. A different choice can point to a different earlier session, so all three setups are replaced with values from that session.
Will it overwrite what you typed?
No. As soon as you change any setup value, auto-fill stops for that session. After that, changing the track, kart, class or date does not touch the setup.
To throw away the whole draft, tap the X at the top left and then Discard changes in the Discard changes? dialog.
Kart and driver weights
Weights in the Weight section of Chassis setup are filled in like this:
- Kart comes from the Weight field of the selected kart (Settings > Karts).
- Driver comes from the Weight field of the current driver (Settings > Drivers).
- If either weight is 0, the value from the copied session stays.
- Measured total is set to 0 on every new session. While it is 0 and both Kart and Driver have a weight, Calculated total (kart plus driver) shows below it.
Kartnote fills these weights even when auto-fill is off.
Previously used values
In Tires setup (Compound) and Engine setup (Plug, Main jet, Idle / pilot jet, Fuel/Oil), tap the clock icon next to a field. You can pick a value you used before. Values from the same kart (and, for the engine, the same engine) are listed first. This list is separate from the switch and stays when auto-fill is off.
Turn it off
- Tap the Settings tab.
- Under Session setup, turn off Auto-fill previous setup.
It is on by default. When it is off, new sessions start with an empty setup apart from the weights.
Auto-fill works during the trial and with Kartnote Full Access. If the trial has ended without a purchase, the row shows a lock, and turning it on opens the purchase screen. See Kartnote Full Access.
If something goes wrong
If the Status row in Settings shows Unable to verify, the switch is greyed out. Tap Retry purchase check in the Kartnote section. If you opened a new session while Kartnote was still checking, the setup fills in when the check finishes, as long as you haven't changed it.